How to Remove Delta Ring Without Tool

There are two ways to remove a delta ring without using any tools. The first method is by using a paperclip. Insert the paperclip into the small hole on the side of the delta ring.

Then, use the paperclip to push down on the locking tab while simultaneously pulling on the delta ring. The second method is by using a flat head screwdriver. Place the tip of the screwdriver under the locking tab and gently pry it up.

As you pry up on the locking tab, pull on the delta ring until it comes off.

  • Using a flat head screwdriver, pry up on the delta ring until it is released from the gas block
  • Once the delta ring is released, slide it off of the barrel assembly
  • The handguard can now be removed from the barrel assembly

-How Do I Remove the Delta Ring Without a Tool

There are a few ways to remove the delta ring without a tool, but it is important to note that doing so may damage the rifle. First, use a flat head screwdriver or another flat object to push down on the tab in the center of the delta ring. This will release tension and allow you to slide the delta ring off.

Second, place the front sight assembly upside down on a table or other flat surface. Use a blunt object like a pen or punch to press down on the small retaining pin in the center of the delta ring. This will release tension and allow you to slide the delta ring off.

Finally, if you have access to an air compressor, you can use it to blow out any dirt or debris that may be preventing the delta ring from sliding off. Be careful not to overdo it, as too much pressure can damage your rifle.

How To: AR-15 Handguard removal WITHOUT TOOLS (M&P 15 sport 2)

Conclusion

In order to remove a delta ring without a tool, the user must first locate the two prongs on the inside of the ring. Once located, the user must use their fingers to push the prongs inwards until they clear the body of the ring. The user can then carefully remove the delta ring from their firearm.

Leave a Comment

Your email address will not be published. Required fields are marked *